Diodes AP7217 Manuel d'utilisateur télécharger pdf (Page 7)

AP7217

500mA CMOS LDO

AP7217

Document number: DS31292 Rev. 4 - 2

7 of 10

www.diodes.com

April 2010

Timing Diagram

20mSec-TYP.

OUT

1.8V

Application Note

Input Capacitor

A 1μF ceramic capacitor is recommended to connect between IN and GND pins to decouple input power supply

glitch and noise. The amount of the capacitance may be increased without limit. A lower ESR (Equivalent Series

Resistance) capacitor allows the use of less capacitance, while higher ESR type requires more capacitance. This

input capacitor must be located as close as possible to the device to assure input stability and less noise. For

PCB layout, a wide copper trace is required for both IN and GND.

Output Capacitor

The output capacitor is required to stabilize and help the transient response of the LDO. The AP7217 is designed

to have excellent transient response for most applications with a small amount of output capacitance. The AP7217

is stable with any small ceramic output capacitors of 1.0μF or higher value, and the temperature coefficients of

X7R or X5R type. Additional capacitance helps to reduce undershoot and overshoot during transient. For PCB

layout, the output capacitor must be placed as close as possible to OUT and GND pins, and keep the leads as

short as possible.

ENABLE/SHUTDOWN Operation

The AP7217 is turned on by setting the EN pin high, and is turned off by pulling it low. If this feature is not used,

the EN pin should be tied to IN pin to keep the regulator output on at all time. To ensure proper operation, the

signal source used to drive the EN pin must be able to swing above and below the specified turn-on/off voltage

thresholds listed in the Electrical Characteristics section under V

and V

OUT

EN=0 0V

EN=1 3.3V

Current Limit Protection

When output current at OUT pin is higher than current limit threshold, the current limit protection will be triggered

and clamp the output current to approximately 600mA to prevent over-current and to protect the regulator from

damage due to overheating.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Diodes AP7217 Manuel d'utilisateur Page 7